Gtco AccuTab VI - Users Guide Instrukcja Użytkownika Pobierz pdf (Strona 37)

AccuTab VI 37

Replacing the Cordless Cursor Batteries

The cordless cursor requires two AAA batteries. The average battery life for the cursor

batteries is 2,000 hours.

To replace the batteries:

1. Place the cursor face down in the

palm of your hand. Use a Phillips

screwdriver to remove the two

screws located on the bottom of

the cursor (see figure). Remove

the cursor base.

2. Remove the old batteries from the

battery casings.

3. Place the new batteries in the

casings, matching the polarity of

each battery with the markings on

the connector strips (match + to

+).

4. Reposition the cursor base.

Replace the screws with the

Phillips screwdriver.

NOTE: When you replace the cordless pen or cursor batteries, the transducer will reset to

the default frequency. If you changed the frequency of the transducer before replacing the

batteries, you will need to do so again after replacing the batteries (see Reducing Monitor

Interference in the next section).

Reducing Monitor Interference

If you are experiencing monitor interference with your tablet, you can reduce the

interference by changing the frequency your transducer uses. This can be done only for

transducers that support changing the frequency.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 45 46

Brak uwag

Gtco AccuTab VI - Users Guide Instrukcja Użytkownika Strona 37