Gtco Summagrid IV - Users Guide Part 2 Instrukcja Użytkownika Pobierz pdf (Strona 13)

Summagrid IV 13

1.14.2 How to Relocate Origin

To relocate the origin to one of the pre-defined locations, send the appropriate

command, listed below under Command Syntax. To change the origin to a specific

user-defined location, follow these steps:

1. Send the command <ESC>F1 to let the tablet know you are redefining the origin.

2. Position the transducer over the desired origin location.

3. Press a button on the transducer to send the new origin location to the system.

Depending on the origin’s location, coordinates can be positive or negative. For example,

an origin centered on the tablet establishes four quadrants, where both negative and

positive X,Y coordinates can be reported.

1.14.3 Command Syntax

Relocate Origin

<ESC>F [b]

lower left corner

user-defined

center

lower right

upper left

upper right

b=0

b=1

b=2

b=4

b=3

b=5

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Brak uwag

Gtco Summagrid IV - Users Guide Part 2 Instrukcja Użytkownika Strona 13